4/25/2023 0 Comments Wooden digital clockIf you used 2 LEDs, then when you insert the LEDs into the holes, place the cathodes in the middle of the hole, so the 2 flat sides meet. Be careful when doing this, the drill bit can catch much easier and pull the board up, poking out the hole. If you used 2 5mm LEDs like me, then you will need to widen the the holes for the LEDs. Be warned that this takes patience, don't rush it or you may burn out a hole and have to restart.įor this step, place one of each type of the LEDs in each hole so they wedge in place. Once you are comfortable with drilling the holes, move on to the final piece of wood and drill out each hole. Repeat this until you are happy with how much light shines through (see pictures below for a reference). ![]() If you don't, it will burn the hole making the face discoloured. The drill is turned off so you can scrape any build-up off of the bottom of the bit. Hold it down for 1 second again then let up and turn the drill off. Line the bit up with a test hole and gently hold down for 1 second and let up. Adjust the depth gauge so the bit is barely above the lower board as in the 3rd picture. On a safety note, this is not how the bit is designed to be used, and is a hazard, so be extra careful. Start by putting the hobby tool bit in the drill press (make sure to leave over 1" out of the chuck). This step is very challenging, the point of it is to use the hobby tool bit to make the hole ends flat so the light shines through evenly. Drill one hole in each of the circles on the template as in the picture below. A strong light should be able to shine through where the tip of the drill ended. Drill at least 10 test holes (they will be used later!). I strongly suggest using a test board first to see if it works. Take a drill bit slightly larger than the flat-ended hobby bit and adjust the depth gauge so that the tip is just 0.8-1mm above the lower board, this is so it doesn't go all of the way through the front board. Take the front board and place it template side up on top of the worst looking board. Tape it to the back side of the front board, so the good side is facing down when the print-out is facing up. Start by printing out the template attached to this step at a 1:1 scale. ![]() Try to avoid any knots or visible defects in the wood because they will make it infinitely harder to drill the LED holes. Improved Feature 3:Simplier and Faster Operation - Compared with the complex operation of the old version, t.Take the best piece of the 1"x4"x1-1/2' board and choose the best side to be the front of the clock. ![]() Improved Feature 2:Volume Adjustable - Compared with the old version that cannot adjust the volume of the alarm, the volume of this new version digital alarm clock is adjustable from 60dB - 90dB, you can set a volume level that suits you. It will never disturb your sleep at night. Improved Feature 1:0~100% Dimmable - Compared with the old version of 3-level dimming, this new version digital alarm clock has more clear LED digits with 0~100% full range dimmable, you can easily adjust to your favorite brightness level. It provide much convenience for you to place or charge your phone. Features: Wireless Charging - Support most universal wireless charging cellphone models.Digital Wooden Alarm Clock with Wireless Charging, 0-100% Dimmer, Dual Alarm, Weekday /Weekend Mode, Snooze, Wood LED Clocks for Bedroom, Bedside, Desk, Kids
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |